Pistenking Kingbus Unimod-RRL Verkerk Rear Lights

Universal Modules for installation at the rear bumper of a model. The module was developed to control the Show Truck Taill Lights by Verkerk . The connector board for the individual tail lights has to be connected to this Universal Module according to the instructions. This allows to control the tail lights with the Kingbus system.

The color of the LED to be connected is marked with a colored point on the module. One wire from the connector board can be connected per outlet.
At the outlets marked with "HC" several LEDs (up to a total of 100mA) may be connected. In this case the correct resistor has to be determined and installed between the universal module and LED (only at the HC outlet)!

The module is delivered ready to install and tested. The connection to the Kingbus lighting system is easy - simply plug it in!
Please note also the wiring diagrams at the pictures below.

Outlets:
- Needed outlets for the tail lights
- Parking light outlet up to 100mA
+ 5 Volt

Technical Data:
- Module dimensions: 27 x 15 x 8mm (LxWxH)
- Cable length: 150mm

Delivery Contents:
- 2 Universal Modules with instructions