Pistenking Kingbus Unimod-UM Universal Module

Universal Modules for installation at the front and rear bumper of a model. Individual LEDs may be connected to the module. No additional resistors are needed as they are already integrated into the module!

The color of the LED to be connected is marked with a colored point on the module. One LED can be connected per outlet.
At the outlets marked with "HC" several LEDs (up to a total of 100mA) may be connected. In this case the correct resistor has to be determined and installed between the universal module and LED (only at the HC outlet)!

The module is delivered ready to install and tested. The connection to the Kingbus lighting system is easy - simply plug it in!
Please note also the wiring diagrams at the pictures below.

Design:
These modules are designed for small models with few lights. For example the low beam and high beam light are realized with just one LED at the front module. The low beam light glows with regular intensity, and if the high beam is switched on the same LED glows brighter. It is the same for the tail light and braking light.
For modern vehicles with sufficient lights we recommend to use two modules each for front and rear (UniMod front and UniMod rear). Please order separately.

Outlets Front Module:
- Low beam + high beam head light (in one LED)
- Low beam + high beam head light (in one LED)
- Turn signal left
- Turn signal right
- Parking light white
- Parking light white
- Parking light HC
+ 5 Volt

Outlets Rear  Module:
- Tail light + braking light (in one LED)
- Tail light + braking light (in one LED)
- Turn signal left
- Turn signal right
- Backing up light
- Rear fog light
- Parking light HC
+ 5 Volt

Technical Data:
- Module dimensions: 27 x 15 x 8mm (LxWxH)
- Cable length: 150mm

Delivery Contents:
- 2 Universal Modules (1x front, 1x rear)