Universal servo controller module with combinable functions and 2 adjustment potentiometers.
A travel limit can be set with the left potentiometer. Turning to the right gives a larger total travel, turning to the left gives a smaller total travel.
The actuating speed can be adjusted with the right potentiometer. Turning to the right gives greater speed, turning to the left gives less speed.
The ServoController Weg-Tip-Delay can be used with receiver connection as well as a switchable module, e.g. operated on a PS4x.
1. Application with servo cable/receiver connection:
- The servo controller Weg-Tip-Delay is plugged into a free receiver channel.
- The servo runs to the left as long as the corresponding transmitter lever is moved to the left.
- Maximum up to the left zero point.
- The servo runs to the right as long as the corresponding transmitter lever is moved to the right.
- Maximum up to the set travel limit.
If the transmitter lever is released between the two end positions, then the servo immediately stops in the current position (jog mode) e.g. to raise/lower a shovel or cannon.
If a simple on/off switch is used in the transmitter instead of the transmitter lever,
- then the servo will run at the set speed when shifting
- from the zero point to the set end point and vice versa.
Typical applications:
Lifelike on/off driving of an aircraft landing gear, unfolding of a loading ramp...
2. Use as a switching function without a separate receiver connection:
- The module is normally supplied with 5 volts on red/brown.
- The orange wire is removed from the servo connector and can be connected to a standard switch module, PS4x.. or Nauticmodul.. can be controlled. (minus active input)
- So you could e.g. with one channel over a PS4a four different servo movements slowed down in a targeted, precise and true-to-nature way.
For all movements, the servo positioning speed is with the right pot adjustable from 0 to 8 seconds for the total travel.
The servo is plugged into the servo controller Weg-Tip-Delay according to the printed colors.
Due to the universal application possibilities, the servo controller replaces "Weg-Tip-Delay" the servo actuators "Slow", "Fast" and "Tipp".
